1 thought on “How to DIY necklace's method of wearing chain diagram”

  1. 1. Fold the rope half a fold, penetrate into the bead, and fix it on the desktop with a large head needle.
    2. Pull the rope on the right to the left and fix it with a large head needle.
    3, then bypass the rope below the rope on the left and wear the circle from the bottom.
    4, unplug the big needle and tighten. Pull the left rope over and fix it.
    5, and then the rope on the right is bypassed the rope just now to the circle from the bottom.
    6, pull out the big needle and tighten.
    7, repeat steps 2-6, edit until the length of half of the wrist, and finally make a knot.
    8. Put another rope through the bead.
    9, start to edit this rope, the same method until it is compiled as long as the rope in the front, and hit a knot.
    10. Cross the two sets of lines and compile this 20 -centimeter rope to three pairs of flat knots.
    11, the tail of the line is put on small accessories, knotted, cut off the remaining line, and burn it with a lighter. A good -looking climbing bracelet is completed.

Leave a Comment